Picture Gallery

Site Search

Site Visitor

Weather


POWER


DSE7510
The DSE7510 is an Automatic Engine ControlModule, designed to provide advanced load share
functionality for diesel and gas generating sets that include nonelectronic and electronic engines. 
The module also provides excellent engine monitoring and protection features.
The module’s load
share functions include, automatic synchronizing with built in synchroscope and closing onto dead
bus. Direct and flexible outputs from the module are provided to allow connection to the most
commonly used speed governors and automatic voltage regulators (AVRs).
The module has been designed to combine a maximum of 16 generators and 16mains (utility)
supplies up to a maximum of 20 in one system, e.g. 16 generators and 4mains (utility) supplies
(DSE7560 required to synchronise with the mains).  The module has the ability to monitor
under/over generator volts, over current, under/over generator frequency, under speed, over
speed, charge fail, emergency stop, low oil pressure, high engine temperature, fail to start,
low/high DC battery volts, fail to stop, generator short circuit protection, reverse power, generator
 phase rotation error, earth fault protection, loss of speed signal, fail to open, fail to close, out of
sync,MPU open circuit failure, negative phase sequence and loss of excitation

 


DSE7520
The DSE7520 is an Automatic Mains Failure Control Module designed to provide advanced load
share functionality for diesel and gas generating sets that include non electronic and electronic
engines, for single set appications and parallel with mains. The module also provides excellent
engine monitoring andprotection features. 
The module monitors the mains (utility) supply and,
upon detection of a loss of power, automatically starts the generating set.
The module’s
synchronizing functions include automatic synchronising with built in synchroscope and closing
onto dead bus. Direct and flexible outputs from the module are provided to allow connection to
the most commonly used speed governors and automatic voltage regulators (AVRs). 
The module has the ability to monitor generator under/over generator volts, over current,
under/over generator
frequency, under speed, over speed, charge fail, emergency stop, low oil pressure, high engine
temperature, fail to start, low/high DC battery volts, fail to stop, generator short circuit protection,
reverse power, generator phase rotation error, earth fault protection, loss of speed signal, fail to
open, fail to close, out of sync,MPU open circuit failure, negative phase sequence and loss of
excitation
 


DSE7560
The DSE7560 is an Automatic Transfer Switch and Mains Control Module, designed to automatically
 synchronise multiple DSE7510s with single or multiple mains (utility) supplies.  The module
instructs the DSE7510s to make precise changes to the generating set outputs. This makes the
module suitable for many applications including peak lopping, peak shaving and no break return.
The module has the ability to monitor the mains (utility) supply and start and stop the generating
sets (being controlled by a DSE7510) upon removal or detection of the mains (utility) supply. The
modules operational status is indicated on the LCD display and the front panel LEDs

 




Copyright © 2010, qaswaa-albararry.com, All rights reserved